ConceptDraw Community

Sorry if this has been posted but I didn't see it anywhere. I'm evaluating this program's abilities as a simple electrical diagram drafting tool. So far so good but I have three questions.

1. Is there a way to move them to different places on the connector as opposed to the middle of the connector?

2. Also, is there a way to keep smart connectors from falling on top of each other? I see a setting to wrap the connectors around objects but not one to make them avoid each other.

3. Finally, is there a way to add extra joints to a smart connector? Sometimes, this would be helpful to ensure that a connector comes at the connection from a direction that keeps it from falling on top of another connector or disappearing along the edge of an object.

Thanks,
Tom

Just to chime in on #2, this is a HUGE problem, especially if you move a connected object, all of the lines reroute on top of each other. This has actually been a problem for as long as I've used CD -- prior to version V at least.

Please, please, PLEASE address this. I've been asking for this for years now.

Sorry, I don't have any answers to the other two, but would like to know as well.